This specialized spreader sticker was created to increase penetration and effectiveness of fungicides with the lowest label rates. Replacing a portion of your high cost chemicals with SS 9 can give a substantial cost savings while being more effective and environmentally responsible! That’s money back in your pocket!

General Information

SS 9 is a special non-ionic surfactant sticker which has been designed with ingredients that will spread evenly and work synergistically with other chemicals. It has also been designed to increase penetration and effectiveness of fungicides. It works so well that growers began using substantially decreased rates of high priced chemicals.  SS 9 is highly effective with chemicals at label rates, in addition, it has proven equally effective with reduced rates of fungicides. Replacing a portion of your high cost chemicals with SS 9 can give a more substantial cost savings while being more effective and environmentally responsible.

Guaranteed Analysis

  • Proprietary Blend Dimethylopysiloxene polyalkylene oxide & non-ionic surfactant: 99.97000%

  • Constituents ineffective as spray adjuvant: 0.03000%



Shake well and mix in enough water to distribute evenly. May be tank mixed with most liquid fertilizers and pesticides. Use in conjunction with a good soil test and soil fertility program. Always conduct a compatibility test prior to mixing any chemicals.



  1. Prior to application, all spray/mixing and application equipment must be cleaned. Carefully observe all cleaning directions on product label.

  2. To prevent or minimize foaming, fill tank 3/4 full of water. In cold weather use water above 60° F to avoid gelling.

  3. Add pesticides and/or fertilizers as directed by label or in following order:

    1. Fertilizer and micronutrients

    2. Dry flowables and dispersible granules

    3. Flowables

    4. Water soluble pesticides

    5. Emulsifiable concentrates

  4. Continue agitation

  5. Add SS9 and mix thoroughly with normal agitation.

  6. Continue filling tank maintaining agitation.

  7. For optimum results spray mixtures containing SS9 should be applied within 36 hours


Application information

The following applications are recommended for:


Aerial as Spreader Sticker:
For optimum results apply 16-32 fl. oz. per 100 gallon of spray


Ground as Spreader Sticker:
Apply 4 to 8 fl. oz. per acre


Agricultural Field Crops as Soil Penetrant with fungicides:
Apply 16 to 32 fl. oz. per acre


Golf Courses as Soil Penetrant:
Apply 32 to 64 fl. oz. per acre


Lawns and Turf as Soil Penetrant:
32 to 64 fl. oz. per acre

Typical Benefits of Use

  • Increased penetration and acceptance by plants of desired chemical

  • Increases effectiveness of fungicides

  • Increases length of effectiveness, allowing increased time between application and/ or less applications

  • Reduction of chemical usage through synergistic effects and less pronounced carryover effects


Disclaimer: The information contained herein is furnished without warranty of any kind. Users should consider this data only as a supplement to other information gathered by them and must make independent determinations of suitability and completeness of information from all sources to assure proper use and disposal of these materials and the safety and health of employees and customers and the protection of the environment.


Store in original container only. Keep container tightly closed. Do not allow water to be introduced into contents of container. Do not contaminate water sources by runoff from cleaning of equipment, disposal of equipment wash water or spray waste. Do not store near heat or open flame. Container Disposal: Triple rinse (or equivalent) container. Offer for recycling or puncture and dispose of according to state and local authorities. If burned, stay out of smoke.


IF SWALLOWED: Give a large amount of water to drink. DO NOT induce vomiting or give anything by mouth to an unconscious person.


IF IN EYES: Immediately flush with clean water for 15 minutes. Consult a physician if symptoms persist.


IF ON SKIN: Remove contaminated clothing and wash with soap and water. If contact is made with the spray solution containing pesticides, follow the “Statement of Practical Treatment” on the pesticide label. Consult a physician if irritation persists.


Avoid contact with skin, eyes, or clothing. Do not apply in such a manner as to directly or through drift expose workers or other people. If mixed with pesticides follow precautionary statements on the accompanying pesticide label.





in Case of Contact

Storage and Disposal